REGULATOR -2
- Up and down braking in accordance with EN 81:20 and EN 81:50 Elevator directives.
- In accordance with EN 81:20 and EN 81:50, it first cuts the safety contact and then brakes.
- It can be installed in the Engine Room and the Well.
- Tensioner pulley with safety contact.
- It can be used for revision and modernization.
- It is adjusted and sealed according to nominal speeds.
- Connection holes are suitable for other speed governors.
- Suitable for Hydraulic and Electric Elevators.
- It is easy to install and does not require maintenance.
- Optional remote control system, encoder and UCM coil are applied.
- Although it is known as a general rule that the regulator braking speed should be equal to 115% of the declared speed, as stated in Article 5.6.2.2.1.1 of the En 81-20 – 50 standards, these articles are also stated in the standard.
- Except for the roller type, non-slip brakes must brake at a maximum of 0.80 m/s.
- Roller type non-slip brakes must brake at a maximum of 1.00 m/s.
- Slide brakes with a nominal speed of 1.00 m/s should brake at a maximum of 1.50 m/s.
- For sliding brakes with a nominal speed of 1.00m/s, the braking speed should be determined with the formula of max 1.25*v + (0.25 / v).
